Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Applications
Note that User Policy is invoked after any Call Policy configured on the VCS has been applied. See
for more information.
Who must do what before FindMe can be used?
The following steps are required for the use of FindMe after the feature has been installed:
1. The VCS administrator:
a.
b. Must define a
(even if the VCS is not part of a cluster).
c. Decides whether to use a local or a remote
service.
If remote authentication is being used, the VCS administrator must also set up User groups.
d. Creates a
for each user or team of people who require a FindMe ID.
2. The owner of the FindMe ID configures their account settings.
See the FindMe deployment guide [
] for more details on setting up FindMe accounts.
Recommendations when deploying FindMe
n
The FindMe ID should be in the form of a URI, and should be the individual’s primary URI.
n
Endpoints should not register with an alias that is the same as an existing FindMe ID. You can
prevent this by including all FindMe IDs on the Deny List.
prevent this by including all FindMe IDs on the Deny List.
Example
Users at Example Corp. have a FindMe ID in the format john.smith@example.com. Each of the
user’s endpoints are registered with a slightly different alias that identifies its physical location. For
example their office endpoint is registered with an alias in the format
john.smith.office@example.com
user’s endpoints are registered with a slightly different alias that identifies its physical location. For
example their office endpoint is registered with an alias in the format
john.smith.office@example.com
and their home endpoint as
john.smith.home@example.com
.
Both of these endpoints are included in the list of devices to ring when the FindMe ID is dialed. The
alias john.smith@example.com is added to the Deny List, to prevent an individual endpoint
registering with that alias.
alias john.smith@example.com is added to the Deny List, to prevent an individual endpoint
registering with that alias.
Note: FindMe is supported by clustering. For information about how FindMe information is managed
across peers in a cluster, refer to
across peers in a cluster, refer to
.
Configuring FindMe
The FindMe configuration page (
Applications > FindMe > Configuration
) is used to enable and
configure
Users configure their FindMe settings by logging into their
. To configure how user
accounts are authenticated, go to the
page.
Note that the FindMe configuration page can only be accessed if the FindMe option key is installed.
Cisco VCS Administrator Guide (X6.1)
Page 188 of 401