Cisco Cisco Web Security Appliance S390 사용자 가이드
2-6
Cisco AsyncOS 8.0.6 for Web User Guide
Chapter 2 Connect, Install, and Configure
System Setup Wizard
System Setup Wizard
Before You Begin:
•
Connect the Appliance to networks and devices.
•
Complete the System Setup Wizard worksheet.
.
•
If you are preparing to run the System Setup Wizard on a virtual appliance, use the loadlicense
command to load the virtual appliance license. Cisco Security Virtual Appliance Installation Guide.
command to load the virtual appliance license. Cisco Security Virtual Appliance Installation Guide.
•
Note that reference information for each configuration item used in the System Setup Wizard is
available at
available at
Warning
Only use the System Setup Wizard the first time you install the appliance or if you want to completely
overwrite the existing configuration.
overwrite the existing configuration.
Step 1
Open a browser and enter the IP address of the Web Security appliance. The first time you run the System
Setup Wizard, use the default IP address:
Setup Wizard, use the default IP address:
https://192.168.42.42:8443
-or-
http://192.168.42.42:8080
where
192.168.42.42
is the default IP address, and
8080
is the default admin port setting for HTTP,
and
8443
is default admin port for HTTPS.
Otherwise, if the appliance is currently configured, use the IP address of the M1 port.
Step 2
When the appliance login screen appears, enter the username and password to access the appliance. By
default, the appliance ships with the following username and password:
default, the appliance ships with the following username and password:
•
Username:
admin
•
Password: ironport
Step 3
Choose System Administration > System Setup Wizard.
Step 4
If the appliance is already configured, you will be warned that you are about to reset the configuration.
To continue with the System Setup Wizard, click the Reset Configuration button. The appliance will
reset and the browser will refresh to the appliance home screen. Begin again at
To continue with the System Setup Wizard, click the Reset Configuration button. The appliance will
reset and the browser will refresh to the appliance home screen. Begin again at
Step 5
Read and accept the terms of the end user license agreement.
Step 6
Click Begin Setup to continue.
Step 7
Configure all settings using the provided reference tables as required.
Step 8
Review the configuration information. If you need to change an option, click the Edit button for that
section.
section.
Step 9
Click Install This Configuration.
A Next Steps page should appear once the configuration installed. However, depending on the IP,
hostname, or DNS settings you configured during setup, you may lose connection to the appliance at this
stage. If a page not found is displayed in your browser, change the URL to reflect any new address
settings and reload the page. Then continue with any post setup tasks you wish to perform.
hostname, or DNS settings you configured during setup, you may lose connection to the appliance at this
stage. If a page not found is displayed in your browser, change the URL to reflect any new address
settings and reload the page. Then continue with any post setup tasks you wish to perform.