Cisco Cisco Web Security Appliance S690 사용자 가이드
410
I R O N P O R T A S Y N C O S 6 . 3 F O R W E B U S E R G U I D E
>
Please enter the SNMPv3 passphrase again to confirm.
>
Which port shall the SNMP daemon listen on?
[161]>
Please enter the SNMPv3 passphrase again to confirm.
>
Which port shall the SNMP daemon listen on?
[161]>
Service SNMP V1/V2c requests? [N]> y
Enter the SNMP V1/V2c community string.
[]> public
[]> public
From which network shall SNMP V1/V2c requests be allowed?
[192.168.1.1]>
[192.168.1.1]>
Enter the Trap target as a host name, IP address or list of IP
addresses separated by commas (IP address preferred). Enter “None” to
disable traps.
[None]> 10.1.1.29
addresses separated by commas (IP address preferred). Enter “None” to
disable traps.
[None]> 10.1.1.29
Enter the Trap Community string.
[]> tcomm
[]> tcomm
Enterprise Trap Status
1. CPUUtilizationExceeded Disabled
2. RAIDStatusChange Enabled
3. connectivityFailure Disabled
4. fanFailure Enabled
5. highTemperature Enabled
6. keyExpiration Enabled
7. linkDown Enabled
8. linkUp Enabled
9. memoryUtilizationExceeded Disabled
10. powerSupplyStatusChange Enabled
11. resourceConservationMode Enabled
12. updateFailure Enabled
13. upstream_proxy_failure Enabled
1. CPUUtilizationExceeded Disabled
2. RAIDStatusChange Enabled
3. connectivityFailure Disabled
4. fanFailure Enabled
5. highTemperature Enabled
6. keyExpiration Enabled
7. linkDown Enabled
8. linkUp Enabled
9. memoryUtilizationExceeded Disabled
10. powerSupplyStatusChange Enabled
11. resourceConservationMode Enabled
12. updateFailure Enabled
13. upstream_proxy_failure Enabled
Do you want to change any of these settings? [N]> y
Do you want to disable any of these traps? [Y]> n
Do you want to enable any of these traps? [Y]> y
Enter number or numbers of traps to enable. Separate multiple numbers
with commas.
[]> 1,3
with commas.
[]> 1,3