Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP 기술 참조

2-62

Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem Command Reference Guide

380265-002

Chapter 2 CGESM Switch Cisco IOS Commands

deny (MAC access-list configuration)

Note

Though visible in the command-line help strings, appletalk is not supported as a matching condition.

To filter IPX traffic, you use the type mask or lsap lsap mask keywords, depending on the type of IPX
encapsulation being used. Filter criteria for IPX encapsulation types as specified in Novell terminology
and Cisco IOS terminology are listed in

Table 2-4

Defaults

This command has no defaults. However; the default action for a MAC-named ACL is to deny.

Command Modes

MAC-access list configuration

Command History

lsap lsap-number mask

(Optional) Use the LSAP number (0 to 65535) of a packet with 802.2
encapsulation to identify the protocol of the packet.

mask is a mask of don’t care bits applied to the LSAP number before
testing for a match.

mop-console

(Optional) Select EtherType DEC-MOP Remote Console.

mop-dump

(Optional) Select EtherType DEC-MOP Dump.

msdos

(Optional) Select EtherType DEC-MSDOS.

mumps

(Optional) Select EtherType DEC-MUMPS.

netbios

(Optional) Select EtherType DEC- Network Basic Input/Output System
(NETBIOS).

vines-echo

(Optional) Select EtherType Virtual Integrated Network Service (VINES)
Echo from Banyan Systems.

vines-ip

(Optional) Select EtherType VINES IP.

xns-idp

(Optional) Select EtherType Xerox Network Systems (XNS) protocol
suite (0 to 65535), an arbitrary Ethertype in decimal, hexadecimal, or
octal.

Table 2-4

IPX Filtering Criteria

IPX Encapsulation Type

Filter Criterion

Cisco IOS Name

Novel Name

arpa

Ethernet II

Ethertype 0x8137

snap

Ethernet-snap

Ethertype 0x8137

sap

Ethernet 802.2

LSAP 0xE0E0

novell-ether

Ethernet 802.3

LSAP 0xFFFF

Release

Modification

12.2(25)SE1

This command was introduced.