Cisco Cisco Agent Desktop 8.5 설치 가이드
Installing CAD 8.5 Using Flat Files (Basic Installation)
March 31, 2014
57
To enter configuration data on the primary base services computer (Side A):
1. The Cisco Agent Desktop Configuration Setup utility starts automatically and
displays the Location of CAD Base services dialog (
Figure 6.
Location of CAD Base services dialog
2. Enter the IP address of the primary CAD base services and then click OK. The
CAD Configuration Setup utility appears.
Complete the fields for each node, using the right arrow on the toolbar or
Ctrl+N to move forward to the next node.
Ctrl+N to move forward to the next node.
■
You cannot move forward until all required information is entered.
■
You cannot skip a node.
■
You can go backwards using the left arrow or Ctrl+B at any time to revisit a
previous node.
previous node.
■
The Save button is only enabled when all nodes are completed.
3. When you have completed all nodes, click Save on the toolbar or choose File >
Save.
When the data is successfully saved, the utility ends automatically.
NOTE: The save process can take several minutes.
NOTE: Once your configuration settings have been saved, Unified CCE
License Administration will launch automatically. Refer to
License Administration will launch automatically. Refer to
for more information. You only have to complete
this step on Side A.