Cisco Cisco IOS Software Release 12.2(15)T 개발자 가이드

Gatekeeper configuration

The following subcommands can be used in any of the trigger submodes:

The following subcommands can be used in specific trigger submodes to configure certain types of 
trigger conditions:

To indicate to the Cisco IOS Gatekeeper that messages that meet the specified trigger parameters should 
be sent as notifications only and that the Cisco IOS Gatekeeper should not wait for a response from the 
external application, use the info-only subcommand.

Any of the Cisco IOS Gatekeeper trigger submodes

arq | lcf | lrj | lrq | 
rrq | urq | drq | rai | 
brq

The RAS messages for which you can create triggers on the 
Cisco IOS Gatekeeper. You can specify only one message type per server trigger 
command. There is a different trigger submode for each message type. Each 
trigger submode has its own set of applicable commands.

The identifier of the Cisco IOS Gatekeeper.

The priority for this particular trigger. Possible values are 1 through 20. 1 is the 
highest.

The identifier of the external application.

The IP address of the server on which the external application is running.

The port on which the server listens for messages from the 
Cisco IOS Gatekeeper.

Informational only. No need to wait for acknowledgment.