Cisco Cisco IPS 4255 Sensor 릴리즈 노트

ROMMON uses TFTP to download an image and launch it. TFTP does not address network issues such 
as latency or error recovery. It does implement a limited packet integrity check so that packets arriving 
in sequence with the correct integrity value have an extremely low probability of error. But TFTP does 
not offer pipelining so the total transfer time is equal to the number of packets to be transferred times 
the network average RTT. Because of this limitation, we recommend that the TFTP server be located on 
the same LAN segment as the sensor. Any network with an RTT less than a 100 milliseconds should 
provide reliable delivery of the image. Be aware that some TFTP servers limit the maximum file size that 
can be transferred to ~32 MB.

For the procedure for downloading IPS software updates from Cisco.com, see 

. 

For the procedure for configuring automatic upgrades, for the CLI refer to 

, for IDM refer to 

, and for IME refer to 

Use the following tools for configuring Cisco IPS 6.2(1) sensors:

Cisco IDM 6.2

Cisco IME 6.2

IPS CLI 6.2

ASDM 5.2 and above

CSM 3.2

Use the following tools for monitoring Cisco IPS  6.2(1) sensors:

Cisco IME 6.2 and 7.0

CSM 4.0

You may need to configure viewers that are already configured to monitor the Cisco IPS 6.1 
sensors to accept a new SSL certificate for the Cisco IPS 6.2(1) sensors.

Cisco IPS 6.2(1)E3 includes the following new features:

Support for IPv6

Cisco IPS software provides protection for both IPv4 and IPv6 networks.

Atomic IP Advanced engine

The Atomic IP Advanced engine enhances the detection capabilities of Cisco IPS platforms with 
native IPv6 inspection capabilities. The engine is active only in version 6.2 of IPS software and later.