Cisco Cisco IPS 4345 Sensor 릴리즈 노트

Release Notes for Cisco Intrusion Prevention System 7.1(4)E4

OL-25389-01

Disabling Anomaly Detection

Enabling Anomaly Detection Using the CLI

To enable anomaly detection, follow these steps:

Step 1

Step 2

Enter analysis engine submode.

sensor# configure terminal

sensor(config)# service analysis-engine

sensor(config-ana)#

Step 3

Enter the virtual sensor name that contains the anomaly detection policy you want to enable.

sensor(config-ana)# virtual-sensor vs0

sensor(config-ana-vir)#

Step 4

Enable anomaly detection operational mode.

sensor(config-ana-vir)# anomaly-detection

sensor(config-ana-vir-ano)# operational-mode detect

sensor(config-ana-vir-ano)#

Step 5

Exit analysis engine submode.

sensor(config-ana-vir-ano)# exit

sensor(config-ana-vir)# exit

sensor(config-ana-)# exit

Apply Changes:?[yes]:

Step 6

Press Enter to apply your changes or enter

to discard them.

For More Information

For more detailed information about anomaly detection, refer to

Disabling Anomaly Detection

The following section explains how to disable anomaly detection through the IDM, IME, or the CLI. It
contains the following topics:

•

•

Disabling Anomaly Detection Using the IDM or IME

To disable anomaly detection, follow these steps:

Step 1

Step 2

Choose Configuration > Policies > IPS Policies.

Step 3

Select the virtual sensor for which you want to turn off anomaly detection, and then click Edit.