Cisco Cisco IPS 4345 Sensor 릴리즈 노트

If the network settings are correct, the system downloads and boots the specified image on the 
IPS 4345. Be sure to use the IPS 4345 image.

For the procedure for locating software, see 

For a list of supported TFTP servers, see 

.

For a list of the specific IPS software files, see 

For the procedure for initializing the sensor with the setup command, see 

.

Be sure the TFTP server that you specify can transfer files up to 60 MB in size.

To install the system image on the ASA 5500-X IPS SSP, follow these steps:

Download the IPS system image file corresponding to your ASA platform to the tftp root directory of a 
TFTP server that is accessible from your adaptive security appliance. 

Make sure you can access the TFTP server location from the network connected to the Ethernet 
port of the adaptive security appliance.

Log in to the adaptive security appliance.

Enter enable mode.

asa> enable

Copy the IPS image to the disk0 flash of the adaptive security appliance.

asa# copy tftp://192.0.2.0/directory/IPS-5545-K9-sys-1.1-a-7.1-3-E4.aip disk0:

Image the ASA 5500-X IPS SSP.

asa# sw-module module ips recover configure image 

Execute the recovery. This transfers the image from the TFTP server to the ASA 5500-X IPS SSP and 
restarts it.

asa# sw-module module ips recover boot

Periodically check the recovery until it is complete.

asa# show module 

Mod Card Type                                    Model              Serial No. 

--- -------------------------------------------- ------------------ -----------

  0 Cisco ASA 5545 Appliance with 8 GE ports, 1  ASA5545            ABC1234D56E