Cisco Cisco IPS 4345 Sensor 릴리즈 노트

  1 IPS 5545 Intrusion Protection System         IPS5545            ABC1234D56E        

Mod  MAC Address Range                 Hw Version   Fw Version   Sw Version     

---  --------------------------------- ------------ ------------ -------------

0    503d.e59c.6dc1 to 503d.e59c.6dca  1.0                       8.6.1

ips  503d.e59c.6dcb to 503d.e59c.6dcb  N/A          N/A          7.1(3)E4

Mod SSM Application Name           Status           SSM Application Version

--- ------------------------------ ---------------- --------------------------

  1 IPS                            Up               7.1(3)E4

Mod Status             Data Plane Status     Compatibility

--- ------------------ --------------------- -------------

  0 Up Sys             Not Applicable        

  1 Up                 Up                    

asa#

The Status field in the output indicates the operational status of the ASA 5500-X IPS SSP. An 
ASA 5500-X IPS SSP operating normally shows a status of “Up.” While the adaptive security 
appliance transfers an application image to the ASA 5500-X IPS SSP, the Status field in the 
output reads “Recover.” When the adaptive security appliance completes the image transfer and 
restarts the ASA 5500-X IPS SSP, the newly transferred image is running. 

To debug any errors that may happen in the recovery process, use the debug module-boot 
command to enable debugging of the system reimaging process.

Session to the ASA 5500-X IPS SSP and initialize it with the setup command.

For the procedure for locating software, see 

For a list of supported TFTP servers, see 

.

For a list of the specific IPS software files, see 

For the procedure for initializing the sensor with the setup command, see 

.

This section describes how to install the ASA 5585-X IPS SSP system image using the hw-module 
command or ROMMON, and contains the following topics: