Cisco Cisco IPS 4520 Sensor 릴리즈 노트

The path is relative to the default tftpboot directory of the UNIX TFTP server. Images located 
in the default tftpboot directory do not have any directory names or slashes in the IMAGE 
specification.

Windows Example 

rommon> IMAGE=\system_images\IPS-4240-K9-sys-1.1-a-7.1.6-E4.img

Enter set and press Enter to verify the network settings.

You can use the sync command to store these settings in NVRAM so they are maintained across 
boots. Otherwise, you must enter this information each time you want to boot an image from 
ROMMON.

Download and install the system image.

rommon> tftp

To avoid corrupting the system image, do not remove power from the IPS 4240 while the system image 
is being installed.

If the network settings are correct, the system downloads and boots the specified image on the 
IPS 4240. Be sure to use the IPS 4240 image.

You can install the IPS 4260 system image by using the ROMMON on the appliance to TFTP the system 
image onto the flash device. 

To install the IPS 4260 system image, follow these steps:

Download the IPS 4260 system image file to the tftp root directory of a TFTP server that is accessible 
from your IPS 4260. 

Make sure you can access the TFTP server location from the network connected to your IPS 4260 
Ethernet port.

Boot the IPS 4260.

Press Ctrl-R at the following prompt while the system is booting.

Evaluating Run Options...

You have five seconds to press Ctrl-R.

Assuming IPS-4260-K9 Platform                                                   

 2 Ethernet Interfaces detected