Cisco Cisco IPS 4520 Sensor 릴리즈 노트

Server—TFTP server IP address where the application image is stored

Gateway—Gateway IP address used by the IPS 4240

Port—Ethernet interface used for the IPS 4240 management

VLAN—VLAN ID number (leave as untagged)

Image—System image file/path name

Config—Unused by these platforms

Not all values are required to establish network connectivity. The address, server, gateway, and 
image values are required. If you are not sure of the settings needed for your local environment, 
contact your system administrator.

If necessary, change the interface used for the TFTP download.

The default interface used for TFTP downloads is Management 0/0, which corresponds to the 
MGMT interface of the IPS 4240.

rommon> PORT=interface_name

If necessary, assign an IP address for the local port on the IPS 4240.

rommon> ADDRESS=ip_address

Use the same IP address that is assigned to the IPS 4240.

If necessary, assign the TFTP server IP address.

rommon> SERVER=ip_address

If necessary, assign the gateway IP address.

rommon> GATEWAY=ip_address

Verify that you have access to the TFTP server by pinging it from your local Ethernet port with one of 
the following commands.

rommon> ping server_ip_address

rommon> ping server

If necessary define the path and filename on the TFTP file server from which you are downloading the 
image.

rommon> IMAGE=path/file_name

Make sure that you enter the IMAGE command in all uppercase. You can enter the other ROMMON 
commands in either lower case or upper case, but the IMAGE command specifically must be all 
uppercase.

UNIX Example 

rommon> IMAGE=/system_images/IPS-4240-K9-sys-1.1-a-7.1.6-E4.img