Cisco Cisco IPS 4520 Sensor 릴리즈 노트

For the procedure for initializing the sensor with the setup command, see 

.

You can install the IPS 4510 and IPS 4520 system image by using the ROMMON on the appliance to 
TFTP the system image onto the compact flash device.

The following procedure references the IPS 4510 but it also refers to the IPS 4520.

To install the IPS 4510 system image, follow these steps:

Download the IPS 4510 system image file to the tftp root directory of a TFTP server that is accessible 
from your IPS 4510. 

Make sure you can access the TFTP server location from the network connected to the 
Management port of your IPS 4510.

Boot the IPS 4510.

Press Break or Esc at the following prompt while the system is booting to interrupt boot. Press the 
spacebar to begin boot immediately.

You have ten seconds to press Break or Esc.

Use BREAK or ESC to interrupt boot.

Use SPACE to begin boot immediately.

The system enters ROMMON mode. The 

rommon>

 prompt appears.

Check the current network settings.

rommon> set

ROMMON Variable Settings:

  ADDRESS=0.0.0.0

  SERVER=0.0.0.0

  GATEWAY=0.0.0.0

  PORT=Management0/0

  VLAN=untagged

  IMAGE=

  CONFIG=

  LINKTIMEOUT=20

  PKTTIMEOUT=2

  RETRY=20

The variables have the following definitions:

Address—Specifies the local IP address of the IPS 4510.

Server—Specifies the TFTP server IP address where the application image is stored.

Gateway—Specifies the gateway IP address used by the IPS 4510.

Port—Specifies the Ethernet interface used for IPS 4510 management.