Cisco Cisco IPS 4520 Sensor 릴리즈 노트

To avoid corrupting the system image, do not remove power from the IPS 4510 while the system image 
is being installed.

If the network settings are correct, the system downloads and boots the specified image on the IPS 4510. 
Be sure to use the IPS 4510 image.

For the procedure for locating software, see 

For a list of supported TFTP servers, see 

.

For a list of the specific IPS software files, see 

For the procedure for initializing the sensor with the setup command, see 

.

Be sure the TFTP server that you specify can transfer files up to 60 MB in size.

This process can take approximately 15 minutes to complete, depending on your network and the size 
of the image.

If the ASA 5500 AIP SSM suffers a failure and the module application image cannot run, you can 
transfer application images from a TFTP server to the module using the adaptive security appliance CLI. 
The adaptive security appliance can communicate with the module ROMMON application to transfer the 
image. 

To install the system image of the ASA 5500 AIP SSM, follow these steps:

Download the system image file to the tftp root directory of a TFTP server that is accessible from your 
adaptive security appliance. 

Make sure you can access the TFTP server location from the network connected to the Ethernet 
port of the adaptive security appliance.

Log in to the adaptive security appliance.

Enter enable mode.

asa# enable

Configure the recovery settings for the ASA 5500 AIP SSM.

asa (enable)# hw-module module 1 recover configure