Cisco Cisco IPS 4520 Sensor 릴리즈 노트
28
Release Notes for Cisco Intrusion Prevention System 7.1(6)E4
OL-27710-01
Reimaging the Sensor
Note
The Status field in the output indicates the operational status of the ASA 5500 AIP SSM. An
ASA 5500 AIP SSM operating normally shows a status of “Up.” While the adaptive security
appliance transfers an application image to the ASA 5500 AIP SSM, the Status field in the
output reads “Recover.” When the adaptive security appliance completes the image transfer and
restarts the ASA 5500 AIP SSM, the newly transferred image is running.
ASA 5500 AIP SSM operating normally shows a status of “Up.” While the adaptive security
appliance transfers an application image to the ASA 5500 AIP SSM, the Status field in the
output reads “Recover.” When the adaptive security appliance completes the image transfer and
restarts the ASA 5500 AIP SSM, the newly transferred image is running.
Note
To debug any errors that may happen in the recovery process, use the debug module-boot
command to enable debugging of the system reimaging process.
command to enable debugging of the system reimaging process.
Step 11
Session to the ASA 5500 AIP SSM and initialize it with the setup command.
Installing the ASA 5500-X IPS SSP System Image
Note
Be sure the TFTP server that you specify can transfer files up to 60 MB in size.
To install the system image on the ASA 5500-X IPS SSP, follow these steps:
Step 1
Download the IPS system image file corresponding to your ASA platform to the tftp root directory of a
TFTP server that is accessible from your adaptive security appliance.
TFTP server that is accessible from your adaptive security appliance.
Note
Make sure you can access the TFTP server location from the network connected to the Ethernet
port of the adaptive security appliance.
port of the adaptive security appliance.
Step 2
Log in to the adaptive security appliance.
Step 3
Enter enable mode.
asa> enable
Step 4
Copy the IPS image to the disk0 flash of the adaptive security appliance.
asa# copy tftp://192.0.2.0/directory/IPS-5545-K9-sys-1.1-a-7.1-6-E4.aip disk0:
Step 5
Image the ASA 5500-X IPS SSP.
asa# sw-module module ips recover configure image
disk0:/IPS-SSP_5545-K9-sys-1.1-a-7.1-6-E4.aip
Step 6
Execute the recovery. This transfers the image from the TFTP server to the ASA 5500-X IPS SSP and
restarts it.
restarts it.
asa# sw-module module ips recover boot