Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point 디자인 가이드

Mesh Multicast Mode.............................. In-Out

Mesh Full Sector DFS............................. enabled

Mesh Ethernet Bridging VLAN Transparent Mode..... enabled

After configuring global mesh parameters, you must configure the following local mesh parameters for 
these specific features if in use in your network:

Ethernet Bridging. Refer to the 

.

Bridge Group Name. Refer to the

Workgroup Bridge. Refer to 

.

Public Safety Band Settings. Refer to the 

.

Cisco 3200 Series Association and Interoperability. Refer to 

Power and Channel Setting. Refer to 

.

Antenna Gain Settings. Refer to the 

.

Dynamic Channel Assignment. Refer to 

For security reasons the Ethernet port on all MAPs is disabled by default. It can be enabled only by 
configuring Ethernet Bridging on the root and its respective MAPs.

Ethernet bridging has to be enabled for two scenarios:

When you want to use the Mesh nodes as bridges. (See 

You do not need to configure VLAN tagging to use Ethernet bridging for point-to-point and 
point-to-multipoint bridging deployments.

When you want to connect any Ethernet device such as a video camera on the MAP using its 
Ethernet port. This is the first step to enable VLAN tagging.