Cisco Cisco ASA for Nexus 1000V Series Switch 기술 매뉴얼

ASA-5512# write memory

ASA-5512# reload

Note: When you try to upgrade the image on the ASA from an FTP server, you can use the copy
ftp flash command. This command allows you to specify parameters, such as remote IP address
and source file name. This procedure is similar to TFTP. However, one limitation with is that you
can not modify the remote IP/source interface (like you can with TFTP). In TFTP mode, options
specified with the tftp-server command can be pulled and executed. But with FTP, there is no
such option. The source interface should always be the outside by default, which cannot be
modified. That is, the FTP server should be reachable from the outside interface.

Use this section to confirm that your software upgrade was successful.

The 

 (

 customers only) supports certain show commands. Use the

Cisco CLI Analyzer in order to view an analysis of show command output.

After the ASA reloads and you have successfully logged into ASDM again, you can verify the
version of the image that runs on the device. See the General tab on the Home window for this
information.

These CLI commands are used in order to verify the upgrade:

Show version—This shows the current image with which the ASA is booted.

1.

Show bootvar—This shows the priority of the image to be used after reload.

2.

Show asdm image—This shows the current asdm image used by ASA.

3.

There is currently no specific troubleshooting information available for this configuration.