Cisco Cisco Industrial Wireless 3702 Access Point 설치 가이드
36
Cisco IW3702 Access Point Getting Started Guide
Configuration
shows the pre-installation configuration setup.
Figure 9
Pre-Installation Configuration Setup
To prime the access point:
1.
Ensure that the Cisco Wireless LAN Controller Management DS Port is connected to the network.
Use the CLI, browser-based interface, or Cisco WCS procedures described in the appropriate Cisco Wireless LAN
Controller guide to perform the following:
Controller guide to perform the following:
a.
Ensure that the access points have Layer 3 connectivity to the Cisco Wireless LAN Controller Management and
AP-Manager Interface.
AP-Manager Interface.
b.
Configure the switch to which your access point is to attach. See the appropriate Cisco Wireless LAN Controller
guide.
guide.
c.
Set the Cisco Wireless LAN Controller as the master so that new access points always join with it.
d.
Ensure that DHCP is enabled on the network.
Note:
The access point must receive its IP address through DHCP.
e.
Ensure that no CAPWAP UDP ports are blocked in the network.
f.
Use a DHCP, DNS, or IP subnet broadcast to ensure that the access point finds the IP address of the controller.
This guide describes the DHCP method to convey the controller IP address. For other methods, refer to product
documentation. See also
documentation. See also
.
2.
Apply power to the access point:
The access point is IEEE 802.3at (30 W) compliant and can be powered by a third-party DC power supply that you
provide. The Cisco power injector option is AIR-PWRINJ1500-2=.
provide. The Cisco power injector option is AIR-PWRINJ1500-2=.
Controller
Layer 3
devices
Cisco wireless
access points
2724
88