Cisco Cisco Aironet 1400 Wireless Bridge 릴리즈 노트
8
Release Notes for Cisco Aironet 1410 Bridges for Cisco IOS Release 12.2(11)JA
OL-4086-01
Important Notes
Power Client n CLI Command Is Not Supported
The bridge does not support the power client n command in the browser or CLI interfaces.
bridge(config-if)# power client n
(where n is a value of 12, 15, 18, 21, 22, 23, 24, or maximum)
The bridge does not perform any action if this command is used.
Default Infrastructure SSID
When VLAN is enabled, the WEP encryption mode and the WEP key are applicable only to a native VLAN.
Any SSID configured should have the Infrastructure-SSID parameter enabled for that SSID. With the
Infrastructure-SSID parameter enabled, the bridge ensures that a non-native VLAN cannot be assigned
to that SSID.
Any SSID configured should have the Infrastructure-SSID parameter enabled for that SSID. With the
Infrastructure-SSID parameter enabled, the bridge ensures that a non-native VLAN cannot be assigned
to that SSID.
ARP Table Is Corrupted When Multiple BVIs Are Configured
The bridge supports only one bridge virtual interface (BVI). Multiple BVIs should not be configured
because the ARP table may become corrupted.
because the ARP table may become corrupted.
Bridge Power Up LED Colors
During power up the bridge LEDs display the following color sequences:
1.
The Install LED is initially turned off.
2.
The Install LED turns amber.
3.
The Status LED turns amber during the boot loader process.
4.
The Ethernet, Status, and Radio LEDs turn green during the loading of the operating system.
5.
The Ethernet, Status, and Radio LEDs turn amber during the loop-back test.
6.
The Status LED starts to blink green then the Ethernet LED starts to blink green.
7.
The Ethernet, Status, and Radio LEDs blink amber twice to indicate that the auto install process has
started.
started.
8.
During the auto install process, the Ethernet, Status, and Radio LEDs turn off for a short time period
then go through a blinking sequence twice. Each LED sequentially blinks at the following rates
before becoming continuously amber:
then go through a blinking sequence twice. Each LED sequentially blinks at the following rates
before becoming continuously amber:
a.
Slow blinking rate of 1 blink/sec.
b.
Medium blinking rate of 2 blinks/sec.
c.
Fast blinking rate of 4 blinks/sec.
9.
The Install LED starts to blink amber to indicate that the bridge is searching for a root bridge.
10.
When the bridge associates to a root bridge, the Install LED turns amber.
11.
When the bridge becomes a root bridge and is waiting for a non-root bridge to associate, the Install
LED blinks green.
LED blinks green.
12.
When the root bridge has a non-root bridge associated, the Install LED turns green.