Cisco Cisco Aironet 1530i Outdoor Access Point 릴리즈 노트

Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 15.2(4)JB6

OL-30935-01

System Requirements

http://www.cisco.com

Step 2

Click Support. The Support and Documentation page appears.

Step 3

Under the Select a Product Name, click Wireless. The Product/Technology Support page appears.

Step 4

Under the Make a Selection to Continue section, click Access Point. Products and Access Point are
highlighted.

Step 5

Select the access point model for which you need the information. For example, click the Cisco Aironet
1260 series. A list of documents appears.

Step 6

Click Configure. A list of configuration documents appears.

Step 7

Click Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 15.2(4)JB6.

Step 8

Navigate to the Managing Firmware and Software chapter.

For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on
Cisco.com:

http://www.cisco.com/cisco/software/navigator.html

The new Cisco IOS software is supported only in these versions of 1550 series :

Note

AP 1550 does not support 64 MB Cisco IOS Release starting from 15.2(4)JA1 in autonomous mode.

Converting a Lightweight Access Point Back to Autonomous Mode

You can convert an access point from lightweight mode back to autonomous mode by loading a Cisco
IOS Release that supports autonomous mode. If the access point is associated with a controller, you can
use the controller to load the Cisco IOS release. If the access point is not associated with a controller,
you can load the Cisco IOS release using TFTP.

The image files and their supported access points are listed in

Table 2

Table 1

Supported Versions

Version

First VID with 128 MB

1552E

VID 04

1552EU

VID 01 (all)

1552I

VID 03

1552H

VID 04

1552S

VID 01 (all)

Table 2

Image File Names

Image File

Supported Access Point

Ap3g2

2600I/2600E, 3600I/3600E, 3700I/3700E

Ap3g1 3500I/3500E,

1260I/1260E

Ap1g1 702