Cisco Cisco 4404 Wireless LAN Controller 기술 참조
9
Deployment Guide for Cisco Guest Access Using the Cisco Wireless LAN Controller, Release 4.1
OL-13691-01
Configuring Guest Access on the Cisco Wireless LAN Controller
b.
Click Apply to disable the WLAN.
c.
In the DHCP Relay/DHCP Server IP Addr edit box, enter a valid DHCP server IP address for this
WLAN.
WLAN.
d.
Under General Policies, check the Admin Status check box.
e.
Click Apply to assign the DHCP server to the WLAN and to enable the WLAN. You are returned to
the WLANs page.
the WLANs page.
Step 4
In the upper-right corner of the WLANs page, click Ping and enter the DHCP server IP address to verify
that the WLAN can communicate with the DHCP server.
that the WLAN can communicate with the DHCP server.
Step 5
Select the appropriate Interface Name from the drop-down menu located on the General Policies tab.
For this example, the interface for the guest WLAN is guest-vlan (assigned in the
).
Step 6
At the Layer 3 tab, check the Web Policy box and select the circle next to Authentication.
Note
Menu options for Layer 2 and Layer 3 Security remain as “None.”
Step 7
Click Apply to save edits for the interface on the running configuration of the WLAN switch.
Step 8
To configure the security policy for the secure WLAN, click the blue drop-down arrow next to secure
WLAN and select Edit.
WLAN and select Edit.
Step 9
Repeat Steps 3 through 5, listed above for the secure WLAN.
Step 10
At the Layer 2 tab, select one of the higher security options from the drop-down Layer 2 Security menu
such as WPA+ WPA2.
such as WPA+ WPA2.
Figure 8
Assigning Layer 2 Security Policy for the Secure WLAN