Cisco Cisco 5508 Wireless Controller 기술 매뉴얼

Go to Wireless > All APs, and select the concerned AP.

a. 

Add the username and password in the 802.1x Supplicant Credentials fields.

b. 

Note: Log−in credentials are used to Telnet, SSH, or console in to the AP.

Configure the High Availability section, and click Apply.

Note: Once saved, these credentials are retained across the WLC and the AP reboots. The credentials
change only when the LAP joins a new WLC. The LAP assumes the username and password that
were configured on the new WLC.

If the AP has not joined a WLC yet, you must console in to the LAP in order to set the credentials.
Issue this CLI command in enable mode:

LAP#lwapp ap dot1x username <username> password <password>

or

LAP#capwap ap dot1x username <username> password <password>

Note: This command is available only for APs that run the recovery image.

The default username and password for the LAP is 

cisco

 and 

Cisco

 respectively.

3. 

The switch acts as an authenticator for the LAP and authenticates the LAP against a RADIUS server. If the
switch does not have the compliant software, upgrade the switch. In the switch CLI, issue these commands in
order to enable the 802.1x authentication on a switch port:

switch#configure terminal