Cisco Cisco Aironet 1240 AG Access Point 릴리즈 노트

Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(7)JA1

OL-8206-01

System Requirements

Follow these steps to disable the radio interfaces using the web-browser interface:

Step 1

Browse to the Network Interfaces: Radio Settings page.

Figure 1

shows the top portion of the Network

Interfaces: Radio Settings page.

Figure 1

Network Interfaces: Radio Settings Page

Step 2

Select Disable to disable the radio.

Step 3

Click Apply at the bottom of the page.

Step 4

If your access point has two radios, repeat these steps for the second radio.

Beginning in privileged EXEC mode, follow these steps to disable the access point radios using the CLI:

If your access point has two radios, repeat these steps for the second radio. Use the no form of the
shutdown command to enable the radio.

Converting to Cisco IOS Software

If your 350 or 1200 series access point does not run IOS software, you can use the conversion utility or
the conversion upgrade image to convert the access point system to IOS software. Use the conversion
utility to maintain the current configuration after the conversion, or load the upgrade image to convert
to IOS software without saving the current configuration. Your access point must be running one of these
VxWorks firmware versions before you can convert to IOS software:

•

350 series access points must be running VxWorks version 12.03T, 12.02T1, 12.01T1, 11.23T, or
11.21

Command

Purpose

Step 1

configure terminal

Enter global configuration mode.

Step 2

interface dot11radio {0 | 1}

Enter interface configuration mode for the radio interface. The
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.

Step 3

shutdown

Disable the radio port.

Step 4

end

Return to privileged EXEC mode.

Step 5

copy running-config startup-config (Optional) Save your entries in the configuration file.