Cisco Cisco Aironet 1200 Access Point 릴리즈 노트

The Cisco Aironet Access Point is a wireless LAN transceiver that acts as the connection point between 
wireless and wired networks or as the center point of a standalone wireless network. In large 
installations, the roaming functionality provided by multiple access points enables wireless users to 
move freely throughout the facility while maintaining uninterrupted access to the network. 

You can configure and monitor 1200 series access points using the command-line interface (CLI), the 
browser-based management system, or Simple Network Management Protocol (SNMP).

You can install Cisco IOS Release 12.2(8)JA on a 1200 series access point that has been configured at 
the factory to run Cisco IOS.

Cisco Aironet 340 and 350 Series Access Points and 1200 series access points that currently run 
firmware version 12.01T or earlier do not support IOS. Do not attempt to load an IOS image on an access 
point that does not run IOS.

To determine the version of IOS running on your access point, use a Telnet session to log into the access 
point and enter the show version EXEC command. This example shows command output from an access 
point running Cisco IOS Release 12.2(8)JA:

ap1200>show version

Cisco Internetwork Operating System Software

IOS (tm) C1200 Software (C1200-K9W7-M), Version 12.2(8)JA

Copyright (c) 1986-2003 by Cisco Systems, Inc.

On access points running IOS, you can also find the software version on the System Software Version 
page in the access point’s web-browser interface.

If your access point does not run IOS, the software version appears at the top left of most pages in the 
web-browser interface. The home page on access points not running IOS looks like the page in 

.