Cisco Cisco Aironet 1040 Series Access Point 기술 매뉴얼
sensitive and can contain up to 32 alphanumeric characters. Do not include spaces in your SSIDs.
You can configure up to 16 SSIDs on your Cisco Aironet 1200 Series Access Point and assign different
configuration settings to each SSID. All the SSIDs are active at the same time; that is, client devices can
associate to the access point using any of the SSIDs.
configuration settings to each SSID. All the SSIDs are active at the same time; that is, client devices can
associate to the access point using any of the SSIDs.
If you want the access point to allow associations from client devices that do not specify an SSID in their
configurations, you can set up a guest SSID. The access point includes the guest SSID in its beacon. The
access point's default SSID, tsunami, is set to guest mode. However, to keep your network secure, you should
disable the guest mode SSID on most access points.
configurations, you can set up a guest SSID. The access point includes the guest SSID in its beacon. The
access point's default SSID, tsunami, is set to guest mode. However, to keep your network secure, you should
disable the guest mode SSID on most access points.
If your access point will be a repeater or will be a root access point that acts as a parent for a repeater, you can
set up an SSID for use in repeater mode. You can assign an authentication username and password to the
repeater-mode SSID to allow the repeater to authenticate to your network like a client device.
set up an SSID for use in repeater mode. You can assign an authentication username and password to the
repeater-mode SSID to allow the repeater to authenticate to your network like a client device.
If your network uses VLANs, you can assign one SSID to a VLAN. Client devices that use the SSID are
grouped in that VLAN.
grouped in that VLAN.
Video
This video shows the configuration described in this document:
AP Configuration
This configuration uses VLANs (1, 2, and 3) with native as V:LAN 1 and mapping to 3 different SSIDs (ONE
, TWO, and THREE) on any Cisco Aironet Access Point.
, TWO, and THREE) on any Cisco Aironet Access Point.
SSID ONE uses WEP encryption.
•
SSID TWO uses WPA-PSK.
•
SSID THREE uses WPA-2-PSK.
•
Assuming the AP Ethernet port is connected to fa 2/1 port of the switch.
•
Broadcasting all 3 SSIDs.
•
If you use a single SSID, use the guest-mode command under the SSID.
•
If you use multiple SSIDs, use the mbssid command under the SSID and under Radio Interfaces
•
Note
: Guest mode overrides multiple basic SSID (MBSSID).
Complete these steps in order to configure the AP:
Step 1. Configure the SSID and map it to respective VLANS.
Enable
Conf t
Dot11 ssid one
Vlan 1
Authentication open
Mbssid Guest-mode
End
Enable
Conf t
Dot11 ssid two
Vlan 2
authentication open
authentication key-management wpa