Cisco Cisco Aironet 1040 Series Access Point 기술 매뉴얼
Ap(config)#
bridge 1 route ip
Ap(config)#
end
Ap#
wr
On the switch:
en
conf t
int fa 2/1
switchport mode trunk
switchport trunk encapsulation dot1q
switchport trunk native vlan 1
switchport trunk allowed vlan 1,2,3
end
Step 4. Verify.
On the AP, use the show dot11 associations command. You must see all 3 SSIDs.
•
ap#
show dot11 associations
802.11 Client Stations on Dot11Radio0:
SSID [one] :
SSID [two] :
SSID [three] :
Ping from the AP to the switch VLAN interface. You should be able to ping.
•
Manage the AP with a Management IP Address
Assign the IP address to the bridge virtual interface (BVI) of the AP:
Enable
Conf t
Int bvi 1
Ip address
No shut
End
Verify
Use the show ip int br command on the AP, and verify that all the interfaces are up and running.
Updated: May 29, 2013
Document ID: 116118