Cisco Cisco Aironet 1040 Series Access Point 릴리즈 노트

Cisco Aironet 702 Series Indoor Access Points

Supported model is 702I

The 702 series access point supports only a single Gigabit Ethernet port.

The 1530 series access points support:

One primary GigabitEthernet 0 port, which is the PoE In port and is also the backhaul port

One Gigabit Ethernet 1 port as the secondary port

The primary port can be configured as the Trunk Port and the secondary as the Access port

No PoE Out capabilities

Cisco Aironet 702 and 1530 series of access points do not support MFP. 702 also does not support the 
ClientLink feature.

The 3700 series access point is supported only in site survey mode. You can install Cisco IOS Release 
15.2(4)JB3a on Cisco Aironet 3700 Series access points to perform site surveys. This release runs on 
these access points with limited functionality. You can manually adjust these settings on the site-survey 
access points:

Channel on each radio

Transmit power on each radio

Enable and disable the radios

Manually set basic and supported transmit rates

Enable advertised cell power in beacons to client to enable DTPC for doing active surveys

Enable and disable SSID broadcast in beacons

Enable open authentication

This section contains information that you should keep in mind when installing 702, 802, 1040, 1140, 
1260, 1530, 1550, 1600, 2600, 3500, 3600, and 3700 series access points.

This section contains installation notes for access points.

Cisco Aironet 1040, 1140, 1250, 1260, and 2600 series access points provide adequate fire resistance 
and low smoke-producing characteristics suitable for operation in a building's environmental air space, 
such as above suspended ceilings, in accordance with Section 300-22(C) of the National Electrical Code 
(NEC) and Sections 2-128, 12-010(3) and 12-100 of the Canadian Electrical Code, Part 1, C22.1.