Cisco Cisco Aironet 1700i Access Points 설치 가이드

The pre-installation configuration setup is shown in 

Controller

Layer 3

devices

Cisco wireless

access points

272488

To perform pre-installation configuration, perform the following steps:

Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use 
the CLI, web-browser interface, or Cisco Prime Infrastructure procedures as described in the 
appropriate Cisco wireless LAN controller guide.

Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller 
Management and AP-Manager Interface.

Configure the switch to which your access point is to attach. See the Cisco Wireless LAN 
Controller Configuration Guide, Release x.x for additional information.

Set the Cisco wireless LAN controller as the master so that new access points always join with 
it.

Make sure DHCP is enabled on the network. The access point must receive its IP address 
through DHCP.