Cisco Cisco Aironet 1040 Series Access Point 릴리즈 노트

Framed attribute is supported with the Autonomous 1040 and 1260 Series Access Points. A new option 
“framed” is added to the existing CLI “dot11 aaa authentication attributes service.” This allows you to 
configure service types as “login” or “framed” depending on the user requirement. CLI syntax:

router(config-t) dot11 aaa authentication attribute service [login-user | framed-user] 

By default the service type “login” will be sent in the access request.

A new Russian Federation regulatory domain -R is defined for this release. This new regulatory domain 
is supported on the Cisco Aironet 1040 and 1260 Series Access Point platforms. The new -R domain is 
supported on 5G radios and has new power tables and channel selections. Because the channel selections 
change frequently, they are not included in this document. For up-to-date information on channel settings 
for your access point, see the Channels and Maximum Power Settings for Cisco Aironet Autonomous 
Access Points and Bridges document. This document is available on cisco.com at the following URL:

http://www.cisco.com/en/US/docs/wireless/access_point/channels/ios/reference/guide/atonchp2.html

The Workgroup-Bridge (WGB) VLAN tagging feature enables segregation of VLAN traffic based on the 
VLAN numbers. 

When this feature is enabled, the WGB removes the 802.1q header while sending the packet from a 
VLAN client to the wireless LAN controller (WLC). WGB gets the packet to a VLAN client without 
802.1q header and WGB code has to be modified to add the 802.1q header while forwarding the frame 
to the switch behind WGB.

WGB updates the WLC with the wired-client VLAN information in the Internet Access Point Protocol 
(IAPP) Association message. WLC treats the WGB client as a VLAN-client and forwards the packet in 
the right VLAN interface based on the source-mac-address. 

In the upstream direction, WGB removes the 802.1q header from the packet while sending to the WLC. 
In the downstream direction while forwarding the packet to the switch connecting the wired-client, the 
WLC sends the packet to WGB without the 802.1q tag and WGB adds a 4-byte 802.1q header based on 
the destination mac-address. 

Enter this command to enable WGB VLAN tagging:

WGB(config)#workgroup-bridge unified-vlan-client ?

This release of IOS supports the Cisco 3201 Wireless Mobile Interface Card (WMIC) in the 3200 Series 
Mobile Access Router (MAR). It does not support the following WMIC modules:

Cisco 3205 Wireless Mobile Interface Card (WMIC)

Cisco 3202 Wireless Mobile Interface Card (WMIC)