Cisco Cisco Aironet 1040 Series Access Point 릴리즈 노트
7
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 15.2(2)JA
OL-23990-01
Important Notes
Antenna Installation
For instructions on the proper installation and grounding of external antennas for 1260 series access
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
Warning
Do not install the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Important Notes
This section describes important information about access points and bridges.
Use FTP or FTPS File Transfer to Upgrade to Cisco IOS Release 15.2(2)JA
You cannot use HTTPS file transfer to upgrade to Cisco IOS Release 15.2(2)JA from previous releases.
Because of the image size for this release, you must use TFTP or FTP file transfer for the upgrade. Refer
to the upgrade instructions at this URL:
Because of the image size for this release, you must use TFTP or FTP file transfer for the upgrade. Refer
to the upgrade instructions at this URL:
Cisco 1040/1140 Series Access Points May Record "watchdog timer expired" as
Last Reset Reason
Last Reset Reason
The following error message sometimes appears as the last reset reason when the access points are power
cycled:
cycled:
Watchdog timer expired
This symptom is observed only in Cisco 1040/1140 Series Access Point and does not have any impact
on functionality. Ignore the “watchdog timer expired” reason after an access point has been power
cycled. You can also overwrite the reset reason to “reload” by rebooting with command operation.
on functionality. Ignore the “watchdog timer expired” reason after an access point has been power
cycled. You can also overwrite the reset reason to “reload” by rebooting with command operation.
Regulatory Update for Japan
This release supports the U regulatory domain for the W52 frequency set (channels 36, 40, 44, and 48)
in Japan for the Cisco Aironet 1200 and 1230 Series. This support was added for the Cisco Aironet 1130
and 1240 series in Cisco IOS Software Release 12.4(3G)JA, which shipped previously. Cisco access
points specified for this new domain ship with a U domain radio. Installed J domain access points are
automatically upgraded to U domain status with this release.
in Japan for the Cisco Aironet 1200 and 1230 Series. This support was added for the Cisco Aironet 1130
and 1240 series in Cisco IOS Software Release 12.4(3G)JA, which shipped previously. Cisco access
points specified for this new domain ship with a U domain radio. Installed J domain access points are
automatically upgraded to U domain status with this release.
For the latest Cisco WLAN compliance status, please visit this URL:
.