Cisco Cisco Aironet 1040 Series Access Point 릴리즈 노트

Cisco IOS Release 15.2(2)JA has the following new features:

This release supports standalone Cisco Aironet 2600 Series Access Points. Detailed information and 
configuration procedures for autonomous (standalone) access point are in Chapter 6 of the Cisco IOS 
Software Configuration Guide for Cisco Aironet Access Points, 15.2(2)JA, 12.4(25d)JA & 12.3(8)JEE, 
which is available on Cisco.com at the following URL:

Although 2600 series access points support CleanAir when connected to a wireless LAN controller, 
standalone 2600 series access point do not support CleanAir.

The 802.11n HT rates apply only to no encryption or WPA2/AES encryption. They do not apply to WEP 
or WPA encryption. If WEP or TKIP encryption is used, the 1040, 1140, 1250, 1260, and 2600 series 
access points and any 802.11n Draft 2.0 clients will not transmit at the HT rates. Legacy rates 
(802.11a/b/g) will be used for any clients using WEP or TKIP encryption.

You can install Cisco IOS Release 15.2(2)JA on Cisco Aironet 3600 and 3500 Series access points and 
on 1550 series outdoor access points to perform site surveys. This release runs on these access points 
with limited functionality. You can manually adjust these settings on the site-survey access points:

Channel on each radio

Transmit power on each radio

Enable and disable the radios

Manually set basic and supported transmit rates

Enable advertised cell power in beacons to client to enable DTPC for doing active surveys

Enable and disable SSID broadcast in beacons

Enable open authentication

This release provides additional support for access points in workgroup bridge mode:

An access point configured as a workgroup bridge can now associate to a root access point using the 
following: