Cisco Cisco Aironet 602 OfficeExtend Access Point 기술 매뉴얼
As shown in this screenshot the default option is disabled. Enter the config network oeap−600
split−tunnel enable command in order to enable the default option.
split−tunnel enable command in order to enable the default option.
Enable split tunnel per Wireless LAN (WLAN)/ Remote LAN basis.
2.
Enter these CLI commands in order to enable WLAN/Remote LAN respectively.
config wlan split−tunnel 1 enable
config remote−lan split−tunnel <remote−lan id> {enable | disable}
Limitations
At present, you cannot disable the split tunnel for OEAP APs at the per−AP level. In order to disable
it, you must create a new WLAN profile and add it in a separate AP group which has all the APs and
it will in turn disable the split tunnel.
it, you must create a new WLAN profile and add it in a separate AP group which has all the APs and
it will in turn disable the split tunnel.
•
The other applications with the well−known printer ports will not work, because the AP treats them as
printer ports.
printer ports.
•
The AP cannot send an ARP request outside the subnet of its own. Therefore, the query fails if the
printer is in a different subnet or on a corporate network.
printer is in a different subnet or on a corporate network.
•
It does not support dynamic service discovery.
•
There are no data path debugs.
•