Cisco Cisco Aironet 1810w Access Point 설치 가이드

The AP supports the following hardware external interfaces:

Three local GigE Ethernet Ports, one uplink GigE port, and one passive pass-through RJ45 
port.

One 10/100/1000BASE-T PoE uplink port.

RS-232 management console interface through RJ-45.

Three 10/100/1000BASE-T ports (local Ethernet ports), one of which also serves as a PoE-Out 
port.

The PoE-Out port provides 802.3af power when the AP is powered by Cisco local power 
supply (AIR-PWR-D=) and ~6.5W power when the AP is powered by 802.3at power. The 
PoE-Out port does not provide any power output when the AP is powered by 802.3af power.

DC power connector.

One RJ-45 passive pass-through port (back to bottom).

Mode button. For information on how to use the Mode button, see 

One multi-color LED status indicator for the AP status. LEDs are also present to indicate 
per-port status for local the Ethernet ports. For information, see the 

Three local Gigabit Ethernet ports available to securely connect wired devices to the network. 

Two integrated 2.4 GHz/5 GHz dual-band antennas located on the sides of the 1810W access 
point under the top housing. Peak antenna gain is approximately 2 dBi and 4 dBi in the 2.4 GHz 
and 5 GHz bands respectively.

A full listing of the access point's features and specification are provided in the Cisco Aironet 1810W 
Series Access Point Data Sheet, at the following URL:

The Cisco Aironet 1810W series access point comes in the model number format AIR-AP1810W-x-K9. 
The ‘x’ in the model number is a placeholder for the regulatory domain. For information on supported 
regulatory domains, see the following page: