Cisco Cisco Aironet 1810w Access Point 문제 해결 가이드
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Configure
Map an RLAN to the AP LAN Ports
WLC Example for Local Switching of LAN Port Data on AP Ethernet Port
Verify
Troubleshoot
Introduction
This document describes how to configure VLAN-to-Ethernet port mappings on the local external
wired LAN ports of the AP1810W and provides sample configurations for bridging the traffic locally
at the Access Point (AP) as well as central switching on the Wireless LAN Controller (WLC).
wired LAN ports of the AP1810W and provides sample configurations for bridging the traffic locally
at the Access Point (AP) as well as central switching on the Wireless LAN Controller (WLC).
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Basic knowledge of trunking and switchport configuration to support APs and the WLC with
the use of trunks.
the use of trunks.
●
Basic knowledge of the use of dynamic interfaces and the Remote LAN feature (RLAN) on
Unified Wireless LAN Controllers.
Unified Wireless LAN Controllers.
●
●
Components Used
The information in this document is based on these software and hardware versions:
Cisco Unified Wireless LAN Controller capable of supporting code version 8.2.130.0*
●
Cisco AP1810W Wireless Access Point
●
*It is highly recommended to install 8.2.130.0 when using AP1810W
The information in this document was created from the devices in a specific lab environment. All of
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
Background Information