Cisco Cisco Aironet 1400 Wireless Bridge 릴리즈 노트

If your bridge is configured at the factory for use in a regulatory domain other than North America or 
Korea, the transmit power options for the power local command differ from the power options listed in 
the Cisco Aironet 1400 Series Bridge Software Configuration Guide and in the Cisco IOS Command 
Reference for Cisco Aironet Access Points and Bridges. The transmit power options for low-power 
bridges are 16, 13, 12, 10, 9, 8, 7, and 4 dBm. Note that the maximum transmit power for your bridge 
depends on your regulatory domain.

The bridge protocol ieee command, which enables Spanning Tree Protocol (STP) on the bridge, now 
contains a suspend option. This option suspends STP on the bridge until you re-enable it.

 lists new event messages added to the Error and Event Messages appendix in the Cisco Aironet 

1400 Series Bridge Software Configuration Guide.

AUTO_INSTALL_STATION_ROLE

The radio is operating in automatic 
installation mode.

Use the station-role command to change 
the role in radio network setting for the 
radio.

AUTO_INSTALL_STATUS

The radio is operating in automatic 
installation mode.

Use the station-role command to change 
the role in radio network setting for the 
radio.

AUTO_INSTALL_IP_ADDRESS_
DHCP:
IP address dhcp selected

The radio is operating in automatic 
installation mode and obtained an IP 
address from a DHCP server.

Use the station-role command to change 
the role in radio network setting for the 
radio.