Cisco Cisco Aironet 1400 Wireless Bridge 설치 가이드

After association, the Ethernet, Status, and Radio LEDs indicate signal strength (see 

)

.

The startup and association sequence depends on the initial bridge configuration, as follows:

Default—The bridge attempts to associate with a root bridge for 60 seconds, and then it attempts to 
associate with a non-root bridge. This timeout limits the amount of time you have to reposition the 
antenna at the non-root location.

Preconfigured—The bridge attempts to associate with a remote bridge in the configured mode, 
either root or non-root. Because there are no timeouts, it is easier to reposition an antenna with poor 
initial antenna positioning.

The following procedures explain how to activate the root and non-root bridges for either default or 
preconfigured bridges.

To activate the root bridge, follow these steps:

Verify that the antenna is pointed in the approximate direction of the remote antenna. If it is not, use 
binoculars or reference objects to find the remote bridge or antenna, and then adjust the root bridge’s 
antenna as required.

Apply power and observe the bridge LEDs.

–44 or stronger

On

On

On

–47 to –44

Fast blink

1

1.

Blinks once per second

On

On

–50 to –47

Medium blink

2

2.

Blinks twice per second

On

On

–53 to –50

Slow blink

3

3.

Blinks four times per second

On

On

–54 to –53

Off

On

On

–57 to –54

Off

Fast blink

On

–60 to –57

Off

Medium blink

On

–63 to –60

Off

Slow blink

On

–66 to –63

Off

Off

On

–69 to –66

Off

Off

Fast blink

–72 to –69

Off

Off

Medium blink

–75 to –72

Off

Off

Slow blink

– 75 or weaker

Off

Off

Off