Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트
7
Release Notes for Cisco Aironet 1300 Series Outdoor Access Point/Bridge for Cisco IOS Release 12.3(4)JA
OL-7096-01
Important Notes
Note
To meet regulatory restrictions, the external antenna configuration and the external antenna must be
professionally installed.
professionally installed.
Note
When installing the dual-coax cable, it is acceptable to unzip or pull the two cables apart at the ends if
more separation is needed between the male F connectors.
more separation is needed between the male F connectors.
Personnel installing the access point/bridge must understand wireless bridging techniques, antenna
alignment and adjustment, and grounding methods. The integrated antenna configuration can be
installed by an experienced IT professional.
alignment and adjustment, and grounding methods. The integrated antenna configuration can be
installed by an experienced IT professional.
Important Notes
This section describes important information about the access point/bridge.
SNTP Replaces NTP
In Cisco IOS Release 12.3(4)JA, access points and bridges support SNTP instead of NTP. This change
improves the reliability of the system time on access points and bridges, allows access points and bridges
to synchronize with any NTP server, and prevents client devices from synchronizing to an access point
or bridge that might not be accurate.
improves the reliability of the system time on access points and bridges, allows access points and bridges
to synchronize with any NTP server, and prevents client devices from synchronizing to an access point
or bridge that might not be accurate.
Default Username and Password Are Cisco
When you open the 1300 series interface, you must enter a username and password. The default
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
Changes to the Default Configuration—Radios Disabled and No Default SSID
In this release, the radio or radios are disabled by default, and there is no default SSID. You must create
an SSID and enable the radio or radios before the access point/bridge will allow wireless associations
from other devices. These changes to the default configuration improve the security of newly installed
access points and bridges.
an SSID and enable the radio or radios before the access point/bridge will allow wireless associations
from other devices. These changes to the default configuration improve the security of newly installed
access points and bridges.
Enabling MBSSIDs Without VLANs Disables Radio Interface
If you use the mbssid configuration interface command to enable multiple BSSIDs on a specific radio
interface but VLANs are not configured on the access point, the access point disables the radio interface.
To re-enable the radio, you must shut down the radio, disable multiple BSSIDs, and re-enable the radio.
interface but VLANs are not configured on the access point, the access point disables the radio interface.
To re-enable the radio, you must shut down the radio, disable multiple BSSIDs, and re-enable the radio.