Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트

This example shows the commands you use to re-enable the radio:

AP(config)# interface d1

AP(config-if)# shut

AP(config-if)# no mbssid

AP(config-if)# no shut

After you re-enable the radio, you can enable VLANs on the access point and enable multiple BSSIDs.

Some wireless client devices, including Dell Axim handhelds and Hewlett-Packard iPaq HX4700 
handhelds, cannot associate to an access point when the access point is configured for QoS. To allow 
these clients to associate, disable QoS on the access point. You can use the QoS Policies page on the 
access point GUI to disable QoS, or enter this command on the CLI:

ap(config-if)#no dot11 qos mode

The proxy Mobile-IP feature is not supported in Cisco IOS Releases 12.3(2)JA and later.

Cisco IOS Release 12.3(4)JA does not support this feature.

Ethernet port settings on the access point/bridge must be set to auto speed and auto negotiation. If you 
use any other setting, the GUI operates very slowly. 

When you configure an access point for TACACS+ administration and to receive an IP address from the 
DHCP server, administrators might be locked out of the access point after it reboots if the administrator 
does not have a local username and password configured on the access point. This issue does not affect 
access points configured with a static IP address. Administrators who have been locked out must regain 
access by using the mode button to reset the unit to default settings.

When configuring the access point/bridge as an access point, you must not configure a loopback 
interface. 

Configuring a loopback interface might generate an IAPP GENINFO storm on your network and disrupt 
network traffic.