Cisco Cisco Aironet 350 Access Points 릴리즈 노트
3
Installation Notes
OL-2386-01
Installation Notes
Installation Notes
You can find the latest release of access point and bridge firmware at the following URL:
Installation in Environmental Air Space
Cisco Aironet 350 series bridges and metal-case access points are suitable for use in environmental air
space in accordance with Section 300-22(c) of the National Electrical Code.
space in accordance with Section 300-22(c) of the National Electrical Code.
Caution
The Cisco Aironet power injector has a smaller operating temperature range (32 to 104
o
F; 0 to 40
o
C)
than the 350 series bridge and metal-case access point. The power injector is not intended for use in
extremely high or low temperatures or in environmental air spaces, such as above suspended ceilings.
extremely high or low temperatures or in environmental air spaces, such as above suspended ceilings.
Antenna Installation
For instructions on the proper installation and grounding of external antennas, refer to the National Fire
Protection Association’s NFPA 70, National Electrical Code, Article 810, and the Canadian Standards
Association’s Canadian Electrical Code, Section 54.
Protection Association’s NFPA 70, National Electrical Code, Article 810, and the Canadian Standards
Association’s Canadian Electrical Code, Section 54.
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Power Considerations
Caution
The operational voltage range for 350 series access points and bridges is 24 to 60 VDC, and the
nominal voltage is 48 VDC. Voltage higher than 60 VDC can damage the equipment.
nominal voltage is 48 VDC. Voltage higher than 60 VDC can damage the equipment.
Caution
Cisco Aironet power injectors are designed for use with 350 series access points and bridges only.
Do not use the power injector with any other Ethernet-ready device. Using the power injector with
other Ethernet-ready devices can damage the equipment.
Do not use the power injector with any other Ethernet-ready device. Using the power injector with
other Ethernet-ready devices can damage the equipment.
System Requirements
You must have a Cisco Aironet 340 or 350 Series Access Point or a 350 Series Bridge to install firmware
version 11.08T1.
version 11.08T1.