Cisco Cisco Aironet 350 Access Points 릴리즈 노트

Your access point must be running firmware version 10.x or later to install firmware version 11.08T1. 
Your bridge must be running version 11.07 to install firmware version 11.08T1.

The firmware version number is in the upper-left corner of most management screens in the web-browser 
interface and at the top of the home (Summary Status) page in the command-line interface.

For instructions on installing access point and bridge firmware:

Follow this link to the Cisco Aironet documentation home page:

http://www.cisco.com/univercd/cc/td/doc/product/wireless/index.htm

Follow this path to the product, document, and chapter:
Aironet 350 Series Wireless LAN Products > Cisco Aironet 350 Series Access Points > Cisco 
Aironet Access Point Software Configuration Guide > Maintaining Firmware > Updating Firmware

Follow this link to the Software Center on Cisco.com and download firmware version 11.08T1:

To upgrade firmware from a file server, you must enter settings on the access point’s or bridge’s FTP 
Server Setup page. Refer to the Cisco Aironet Access Point Software Configuration Guide for more 
information.

When you update the firmware on an access point or bridge, allow the unit to finish its start-up sequence 
before removing power. If you update the firmware and remove power before the unit finishes the 
start-up sequence, the radio firmware might be corrupted, making the unit inoperable. If the radio 
firmware is corrupted, the radio indicator (the bottom of the three indicators on top of the access point 
or bridge) lights solid red, and the following error message appears when the access point or bridge starts 
up:

Failed to start driver for port “awc0” (errno=0x006d0002)

If the radio firmware is corrupted, you must return the unit to Cisco for service.