Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트
6
Release Notes for Cisco Aironet 1310 Outdoor Access Point/Bridge for Cisco IOS Release 12.3(2)JA
OL-6723-01
Installation Notes
Warning
Do not work on the system or disconnect cables during periods of lightning activity.
Warning
Do not operate your wireless network near unshielded blasting caps or in an explosive environment
unless the device has been modified to be especially qualified for such use.
unless the device has been modified to be especially qualified for such use.
Warning
In order to comply with radio frequency (RF) exposure limits, the antennas for this product should be
positioned no less than 6.56 ft. (2 m) from your body or nearby persons.
positioned no less than 6.56 ft. (2 m) from your body or nearby persons.
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
accessed only through the use of a special tool, lock and key, or other means of security.
Vehicle Installations
The following warnings apply to vehicle installations:
Warning
A readily accessible two-pole disconnect device must be incorporated in the fixed wiring.
Warning
Connect the unit only to CD power source that complies with the safety extra-low (SELV) requirements
in IEC 60950 based safety standards.
in IEC 60950 based safety standards.
Safety Information
Follow the guidelines in this section to ensure proper operation and safe use of the 1300 series.
FCC Safety Compliance Statement
FCC Compliance with its action in ET Docket 96-8, has adopted a safety standard for human exposure
to RF electromagnetic energy emitted by FCC-certified eqipment. When used with approved Cisco
Aironet antennas, Cisco Aironet products meet the uncontrolled environmental limits found in OET-65
and ANSI C95.1, 1991. Proper operation of this radio device according to the instructions in this
publication results in user exposure substantially below the FCC recommended limits.
to RF electromagnetic energy emitted by FCC-certified eqipment. When used with approved Cisco
Aironet antennas, Cisco Aironet products meet the uncontrolled environmental limits found in OET-65
and ANSI C95.1, 1991. Proper operation of this radio device according to the instructions in this
publication results in user exposure substantially below the FCC recommended limits.
Safety Precautions
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.:NFPA 70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.:NFPA 70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).