Cisco Cisco Aironet 350 Workgroup Bridges 릴리즈 노트
F I R S T D R A F T - C I S C O C O N F I D E N T I A L
2
Release Notes for Cisco Aironet 350 Series Workgroup Bridges Running Firmware Release 8.89
OL-6341-01
Introduction
Introduction
Workgroup bridges are small, standalone units that provide wireless infrastructure connections for
Ethernet-enabled devices. A device connected to a bridge communicates with a network infrastructure
through Cisco Aironet access points.
Ethernet-enabled devices. A device connected to a bridge communicates with a network infrastructure
through Cisco Aironet access points.
The workgroup bridge connects to a hub through a standard Ethernet port using a 10BASE-T (twisted
pair) RJ-45 connector, and up to eight wired Ethernet client devices can be connected to the hub. You
can use an Internet browser or Telnet to configure the workgroup bridge.
pair) RJ-45 connector, and up to eight wired Ethernet client devices can be connected to the hub. You
can use an Internet browser or Telnet to configure the workgroup bridge.
System Requirements
You must have a Cisco Aironet 350 Series Workgroup Bridge to install firmware version 8.89.
Minimum Firmware Version Required on Access Points
Access points with which the workgroup bridge associates must contain firmware version 11.06 or later.
Upgrading to a New Firmware Release
Finding the Firmware Version
The firmware version number is in the upper-left corner of most management screens in the web-browser
interface and at the top of the home (Summary Status) page in the command-line interface.
interface and at the top of the home (Summary Status) page in the command-line interface.
Obtaining the Workgroup Bridge Image
The workgroup bridge image file can be obtained from the Cisco.com software center using these steps:
Step 1
Follow this link to the Software Center on Cisco.com, and download firmware version 8.89:
Step 2
Click Option 2: Aironet Wireless Software Display Tables.
Step 3
Find the workgroup bridge firmware and utilities section, and click Cisco Aironet 350 Series.
Step 4
Click WGB350v889.exe, the workgroup bridge image file.
Step 5
On the Encryption Authorization Form, enter the requested information, read the encryption
information, and check the boxes that apply.
information, and check the boxes that apply.
Step 6
Click Submit.
Step 7
Read and accept the terms and conditions of the Software License Agreement.
Step 8
Select the image file again to download it.
Step 9
Download and save the image file to your hard drive, and then exit the Internet browser.