Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트
8
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 12.4(21a)JA1
OL-20668-01
Installation Notes
Figure 1
Improper Power Configuration Using Two Power Sources
Configuring Power for 1130, 1140, 1240, and 1250 Series Access Points
The 1130, 1140, 1240, and 1250 series access points disable the radio interfaces when the connected
power source does not provide enough power. Depending on your power source, you might need to enter
the power source type in the access point configuration. Use the System Software: System Configuration
page on the web-browser interface to select a power option.
power source does not provide enough power. Depending on your power source, you might need to enter
the power source type in the access point configuration. Use the System Software: System Configuration
page on the web-browser interface to select a power option.
shows the System Power Settings
section of the System Configuration page.
Figure 2
Power Options on the System Software: System Configuration Page
The PoE power status can also be found in the PoE Status section on the network interfaces>network
status page on the access point GUI. The status statements can include any of the following:
status page on the access point GUI. The status statements can include any of the following:
•
Normal (full power)
•
Low (radio disabled)
•
Lower than 15.4 W
•
Lower than 16.8 W
Using the AC Power Adapter
If you use the AC power adapter to provide power to the access point, you do not need to adjust the access
point configuration.
point configuration.
Universal
power supply
SYST
RPS
DUPLX
MODE
SPEED
UTIL
STAT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
23
24
10Base-T / 10
0Base-TX
100Base-FX
Catalyst 2950
SERIES
Switch with
inline power or
power patch panel
Access point
74329