Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트

Repeater access points and workgroup bridges cannot associate to an SSID configured for Layer 3 
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.

You must use a Wireless LAN Services Module (WLSM) as your WDS device in order to properly 
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not 
support Layer 3 mobility, client devices cannot associate using that SSID.

The following sections lists 

 in Cisco IOS Release 12.4(21a)JY. For 

your convenience in locating caveats in Cisco’s Bug Toolkit, the caveat titles listed in this section are 
drawn directly from the Bug Toolkit database. These caveat titles are not intended to be read as complete 
sentences because the title field length is limited. In the caveat titles, some truncation of wording or 
punctuation might be necessary to provide the most complete and concise description. The only 
modifications made to these titles are as follows:

Commands are in boldface type.

Product names and acronyms may be standardized.

Spelling errors and typos may be corrected.

If you are a registered cisco.com user, view Bug Toolkit on cisco.com at the following website:

To become a registered cisco.com user, go to the following website:

 lists caveats that are open in Cisco IOS Release 12.4(21a)JY.

CSCte08161

Cannot get IP address from server if key-management is “wpa optional”

CSCtg09159

Radio may get stuck in RESET or DOWN state

CSCte49042

AP GUI, "admin access" "local user list" issues

CSCte54696

WGB is failed to associate in mixed mode

CSCte63393

Initial 3-4 seconds voice loss observed between Wireless to wired phones