Cisco Cisco Aironet 350 Workgroup Bridges 설치 가이드

Wired LAN

Workstation

on the wireless LAN

Workgroup

bridge

File server

Workstation

on the wired LAN

Access point

39276

The workgroup bridge communicates only with Cisco Aironet Access Points.

Adjust the following settings on the access point to allow it to communicate with the 

bridge:

— On the access point’s 

Express Setup management 

page, set the access point’s 

SSID to tsunami, which 

matches the bridge’s 

default SSID.

— On the access point’s AP 

Radio Data Encryption 

management page, set the 

encryption mode to off. 

To configure the bridge using a computer connected to your network with an access point 

and DHCP server, continue with Steps 2 through 4. 

If you do not have a DHCP server, set your PC to an address of 192.168.200.5. Then open 

the browser or Telnet to 192.168.200.1. Skip to the “Configure the Bridge” section.

Place the bridge in the vicinity of an access point and plug in the power adapter. 

The bridge communicates with the access point when you apply power to the bridge. If 

your network uses a DHCP server, and if the bridge’s Ethernet port is connected to a device, 

the bridge receives an IP address on your network. When the bridge’s IP address is changed 

from the default setting, it can no longer be set using the IPSU.

When the status LED on the bridge is green (to show association of the bridge to the access 

point), go to the association table. Find the entry WGB3XX_xxxxxx (xxxxxx is the last 

six digits of the access point’s MAC address). 

Record the IP address of that entry. Browse to the bridge’s management home page and 

complete the configuration by following the steps in the “Configure the Bridge” section.