Cisco Cisco Aironet 350 Workgroup Bridges 설치 가이드

ETHERNET

SPEED

LED

100BaseTX

SOLID

10BaseT

BLINK

1X 2X

3X 4X

5X

6X

7X

MDI

MDI-X

8X

Wired LAN

Hub on

wired LAN

Ethernet
cable

Workgroup

bridge

Workstation

39284

If the bridge is connected to the wired LAN and is communicating with an access point 

on the same LAN, a network problem known as a bridge loop can occur. Avoid a bridge loop 

by disconnecting the bridge from the wired LAN immediately after you configure it. For more 

information on bridge loops, refer to the Cisco Aironet Workgroup Bridge Hardware 

Installation Guide.

Use a straight-through 

Ethernet cable to connect the 

bridge to a standard port on a 

hub on your wired network. 

Plug in the bridge’s power 

adapter. The bridge receives a 

DHCP-assigned IP address.

Double-click the IPSU icon 

on your desktop to start the utility. 

When the utility window opens, make sure Get IP addr is selected in the Function box. 

Enter the bridge’s MAC address in the Device MAC ID field. The bridge’s MAC address is 

printed on the label on the bottom of the unit. It should contain six pairs of hexadecimal 

digits. Your bridge’s MAC address might look like the following example: 11223a4D5566. 

The MAC address field is not case-sensitive.

Click Get IP Address.

When the bridge’s IP address appears in the IP Address field, write it down. 

If IPSU reports that the IP address is 192.168.200.1, the default IP address, then the bridge 

did not receive a DHCP-assigned IP address. To assign an IP address, go to Step 8. The 

computer you use to assign an IP address to the bridge must have an IP address of its own. 

If you do not need to assign an address, skip to Step 13.

Make sure Set Parameters is selected in the Function box of the IPSU window.

Enter the bridge’s MAC address in the Device MAC ID field.