Cisco Cisco Aironet 350 Workgroup Bridges 릴리즈 노트
2
Release Notes for Cisco Aironet 350 Series Workgroup Bridges Running Firmware Version 8.85
OL-5217-01
Introduction
Defect caveat CSCec11918 identifies and describes an erroneous behavior that occurs when you upgrade
the software on a Cisco Aironet 350 Series Workgroup Bridge. It is less likely to occur when you change
the workgroup bridge configuration. The failure mode associated with this defect is that after the
software upgrade is attempted, the workgroup bridge does not accept the upgrade.
the software on a Cisco Aironet 350 Series Workgroup Bridge. It is less likely to occur when you change
the workgroup bridge configuration. The failure mode associated with this defect is that after the
software upgrade is attempted, the workgroup bridge does not accept the upgrade.
Version 8.85 resolves this problem when it is installed immediately after running the upgrade patch.
Note
The upgrade patch and version 8.85 are intended for use only if a firmware upgrade is required. Cisco
recommends not running the patch or upgrading the firmware unless it is absolutely necessary to do so.
recommends not running the patch or upgrading the firmware unless it is absolutely necessary to do so.
System Requirements
You must have a Cisco Aironet 350 Series Workgroup Bridge to install the upgrade patch and firmware
version 8.85.
version 8.85.
Minimum Firmware Version Required on Access Points
Access points with which the workgroup bridge associates must contain firmware version 11.06 or later.
Upgrading to a New Firmware Release
Finding the Firmware Version
The firmware version number is in the upper-left corner of most management screens in the web-browser
interface and at the top of the home (Summary Status) page in the command-line interface.
interface and at the top of the home (Summary Status) page in the command-line interface.
Upgrade Procedure
For instructions on installing access point and bridge firmware:
Step 1
Follow this link to the Software Center on Cisco.com and download firmware version 8.84:
Step 2
Select Option #1: Aironet Wireless Software Selector. The Aironet Wireless Software Selector
window appears.
window appears.
Step 3
Click the drop-down arrow to view the valid values for the Product Type field.
Step 4
Click Workgroup Bridge.
Step 5
Click Submit. The Step 2 of 3 page appears.
Step 6
Click the drop-down arrow to view the valid values in the Model Number field.
Step 7
Select 350 Series (802.11b).
Step 8
Click Submit. The Step 3 of 3 page appears.