Cisco Cisco Aironet 350 Access Points 릴리즈 노트

You can safely shut off power after a firmware update when the configuration management pages 
reappear in the command-line or web-browser interfaces, or when the three status indicators on top of 
the unit complete the following pattern:

All three indicators are continuously green, meaning that the access point is beginning to update the 
firmware.

The middle indicator is steady green and the top and bottom indicators are off, indicating that the 
access point or bridge is updating the radio firmware. 

When the middle indicator blinks or the top and bottom indicators blink, you can remove power.

This section applies to wireless networks set up to use LEAP. If you do not use LEAP on your wireless 
network, you can skip this section.

Wireless client devices use Extensible Authentication Protocol (EAP) to log onto a network and generate 
a dynamic, client-specific WEP key for the current logon session. If your wireless network uses WEP 
without EAP, client devices use the static WEP keys entered in the Aironet Client Utilities. 

If you use Network-EAP authentication on your wireless network, your client devices and access points 
must use the same 802.1x protocol draft. For example, if the radio firmware on the client devices that 
will associate with an access point is 4.16, the access point should be configured to use Draft 8 of the 
802.1x protocol. 

 lists firmware versions for Cisco Aironet products and the draft with which they 

comply.

PC/PCI cards 4.13

—

x

—

PC/PCI cards 4.16

—

x

—

PC/PCI cards 4.23

—

x

—

PC/PCI cards 4.25 and later

—

—

x

WGB34x/352 8.58

—

x

—

WGB34x/352 8.61 or later

—

—

x

AP34x/35x 11.05 and earlier

—

x

—

AP34x/35x 11.06 and later

1

1.

The default setting in access point VxWorks firmware version 11.06 and later is 802.1x-2001.

—

x

x

AP34x/35x 11.07 and later

—

x

x

AP34x/35x and BR35x 11.21 
through 12.05

—

x

x

AP12xx 11.40T and later

—

x

x