Cisco Cisco Aironet 350 Workgroup Bridges 릴리즈 노트

Workgroup bridges are small, standalone units that provide wireless infrastructure connections for 
Ethernet-enabled devices. A device connected to a bridge communicates with a network infrastructure 
through Cisco Aironet Access Points.

The bridge connects to a hub through a standard Ethernet port using a 10BASE-T/RJ-45 (twisted pair) 
connector, and up to eight client devices can be connected to the hub. You can use an Internet browser 
or Telnet to configure the bridge. 

The bridge communicates with Cisco Aironet Access Points, but it does not communicate with wireless 
networking devices manufactured by other companies.

You must have a Cisco Aironet 340 or 350 Series Workgroup Bridge to install firmware version 8.65_2.

Access points with which the bridge associates must contain firmware version 11.05 or later. The 
firmware version number appears in the upper-left corner of most access point management screens in 
the browser interface and at the top of the home (Summary Status) page in the command-line interface.

The firmware version number appears in the top left corner of the screen in the browser-based 
management system. To view the browser-based management system, type the device’s IP address in the 
Internet browser address line.

Follow these steps to upgrade the firmware in your workgroup bridge:

Use one of the following URLs to find firmware version 8.65_2:

http://www.cisco.com/pcgi-bin/tablebuild.pl/aironet-340

or

http://www.cisco.com/pcgi-bin/tablebuild.pl/aironet-350

Make sure you select firmware version 8.65_2 for 340 and 350 series workgroup bridges. Loading 
firmware version 8.65_2 for 340 series wireless bridges can disable your workgroup bridge.