Cisco Cisco Aironet 350 Workgroup Bridges 릴리즈 노트

In the Filename column, select and click [firmware version 8.65_2 for workgroup bridges]. Follow the 
instructions for saving the file to your local drive.

Use an Internet browser to open the management system on the bridge. To browse to the management 
system, type the bridge’s IP address in the browser address line and press Enter.

When the management system opens, click Allow Config Changes in the top left corner of the page. 

Click Load in the Diagnostics column near the top of the page.

In the Value column, click Browse. Find the local drive where you saved the new firmware version and 
select the firmware file.

Click Send. The new firmware is loaded and the bridge reboots.

This section describes new features in firmware version 8.65, which are also included in version 8.65_2.

Firmware version 8.65_2 uses 802.1x protocol draft 10. If your workgroup bridge uses Extensible 
Authentication Protocol (EAP) to log onto a network, the access point with which the bridge associates 
must use 802.1x protocol draft 10, also.

 lists firmware versions for Cisco Aironet products and the 802.1x protocol draft with which they 

comply.

PC/PCI cards 4.13

—

x

—

PC/PCI cards 4.16

—

x

—

PC/PCI cards 4.23

—

x

—

PC/PCI cards 4.25 and later

—

—

x

WGB34x/352 8.58

—

x

—

WGB34x/352 8.65_2

—

—

x

AP34x/35x 11.05 and earlier

—

x

—

AP34x/35x 11.06 and later

1

1.

The default draft setting in access point firmware version 11.06 and later is 
Draft 10.

—

x

x

AP34x/35x 11.07 and later

—

x

x

AP34x/35x and BR35x 11.08T

—

x

x